Re: Sanyo DS13630

There is most likely a thermo sensitive component in either the power
supply, or one of the scan circuits that is going off value when the set
reaches near or at its operating temperature.  With proper troubleshooting
this can be found and serviced.

-- 

Greetings,

Jerry Greenberg       GLG Technologies GLG
=========================================
WebPage         http://www.zoom-one.com
Electronics        http://www.zoom-one.com/electron.htm
=========================================


"www.ttdown.com" <[EMAIL PROTECTED]> wrote in message
news:[EMAIL PROTECTED]
I have a Sanyo that goes through POST comes on fine works for a few
minutes then shuts off. Yes, I have checked to make sure it isn't the
sleep timer, any other suggestions would be appreciated. It also isn't
"loss of signal power off" I have it hooked to cable. Thanks...Later