Re: 1100 zxi winterizing

Dog gone, Billy you are real ass hole. How in the world you survived in this
business I will never figure it out.
What will you when Miller retires and SBT finds out how dumb you realy are.
Go back to moderate your special interest group where you can rape people
from their bank accounts with out giving them a chance to find out reality
of your intent.
Dude you are one sick moron.
GJG
"W.S. O'Neal" <[EMAIL PROTECTED]> wrote in message
news:[EMAIL PROTECTED]
> Giz,
> That is not possible.
>
> According to the resident *self proclaimed newsgroup saviour* George,  A
> ball bearing cannot "perform well" with horiziontal load.
>
> I just read that. So you must be wrong.
>
> Or maybe he was talking about bearings for wooden wagon wheels such as the
> ones used in his prime.
>
> I wonder how the big 22 inch wide right rear tire and rim stay on our
860hp
> sprintcar when the driver throws it into a rough dirt track corner at over
> 100 mph lap after lap, race after race. It has a single ball bearing
> supporting the axel and hub as the tire gets very good side bite while
> sliding up against the cushion in the turn.
>
>  Gee, all us race car guys must just get lucky.........
>
> Or George doesn't know everything about modern day bearing technology.
>
> Which do you think is the correct answer?
>
> That statement by George was almost as dumb as the one before it where he
> said Kawasaki pumps don't come with marine grade grease in them and
> everybody should run out to their garages and repack their pump bearings.
> Whatta' wizard........
>
> Bill O'Neal
> WCM
> "The_Giz" <[EMAIL PROTECTED]> wrote in message
> news:[EMAIL PROTECTED]
> > "Ball bearing designed to absorb
> > vertical trust of the shaft, they do not perform well in horizontal
trust
> > application."
> >
> > Once again your lack of formal education and your inability to
comprehend
> > technical data makes you look trite and foolish.  Angular-contact radial
> > ball bearings are *designed* to accept both axial and radial loads.
> >
> > Giz
> >
> >
>
>