Re: Daddy needs help with cases and cylinders.

By all means Greg clean up flashing crap from case surface. That staff is
very hard on rotating parts.
A blueprinted engine outlives its brother many times over. Do not change
port height or width.

George Ski
HPT Sport USA
www.hpt-sport.com
270-898-2617

"Thunderpimp" <[EMAIL PROTECTED]> wrote in message
news:[EMAIL PROTECTED]
> ummmmm....
>
> 785 motor-
>
> the cases have casting flash all over they place, should it be cleaned
> up?
>
> anything else i should do to the with them, that won't screw them up?
>
> on the cylinders, the boost port ( the one across from the exhaust, or
> is that the transfer) is an ill fit sleeve to cylinder.  i matched them
> up without widening the port, i'm concerned about charge velocity and
> all the other parameters i'm clueless about.  anythig else i wanna do
> here?
>
> greg