Re: Two-piece stick setup -> How to prevent loose blade (tricks?)

I have a hockey shop and do this every day.  The correct way is to scrape
all glue off, then place two strips of black friction tape ove the blade
butt end.  Heat the tape till bubbly, then cover with glue.  SLide it in the
shaft.  It won't rock no more
"J.W." <[EMAIL PROTECTED]> wrote in message
news:[EMAIL PROTECTED]
> I just got my first 2-piece setup. Bauer aluminum shaft and an Easton
> blade.
>
> Even with a very careful job of heating the glue up and inserting the
> blade into the shaft did not prevent the blade from being slightly
> loose. Most of the glue just gets pushed out when you insert the
> blade.
>
> Is there a trick to this?