Re: Two-piece stick setup -> How to prevent loose blade (tricks?)

"J.W." <[EMAIL PROTECTED]> wrote in message
news:[EMAIL PROTECTED]
> I just got my first 2-piece setup. Bauer aluminum shaft and an Easton
> blade.
>
> Even with a very careful job of heating the glue up and inserting the
> blade into the shaft did not prevent the blade from being slightly
> loose. Most of the glue just gets pushed out when you insert the
> blade.
>
> Is there a trick to this?

Use a glue gun and add a fair bit of glue to the blade, and also put some in
the shaft.  Make sure both are heated real good first, and then dump the
glue, and pop it in.  Let the glue dry and then you can ship away at the
excess on the outside, but be careful not to break the seal it creates.
I've gone a half a season without any problems.  Just use more glue, and use
it in the shaft.