Re: how to service Graphic roll holder?

I think this is how it goes on a 23 graphic. On the side opposite the
plastic cover, the four screws located near the periphery of the metal plate
secure only the plastic casing and can be removed. Don't remove the large
silver screw (spool pivot), the one in the middle near the arrow, or the one
at the end in the middle (adjacent to roller and spool drive). To remove
windon knob, hold spool drive (grey bit with tabs) and turn knob in the
opposite direction to the arrows marked on it. The counter wheel is on the
end of the middle screw (near arrow). This screw should not be removed as it
forms a pivot for some of the mechanism parts. Hold it with a screwdriver
and loosen off the counter wheel slightlyby turning it counter clockwise. I
then recommend you put a bit of tape over the screwhead to stop it falling
out and then fully unscrew the counter wheel with the plastic casing
uppermost. Cover hopefully now comes off without disturbing mechanism.
You'll have to slide the silver catch lever through its slot.

Hope this helps you,
Regards,
John

"_" <[EMAIL PROTECTED]> wrote in message news:[EMAIL PROTECTED]
> Can anyone tell me how to remove the top cover counter and wind knob
> from a Graphic Roll Holder?
>
>
> Thanks in advance-
> Andrew
>