Re: was someone here designing a ribbon mic pre-preamp?

spud wrote:
 
> Lost this thread. Any success with the in-line pre amp booster
> project?

Yes. I built one for my Bang & Olufsen microphone from some SIL Hitachi
chips that are/were aimed for use as lo-output mc preamps and similar.
No extensive testing done, do not read me as claiming it to be "very
good", I only say that it can be done with some, as yet unspecified
result. An inline transformer may be better suited than electronics.

{leaving the context in]

> I need a bit more gain in between a pair of MXL603's and the
> Tascam US224. I power the 603's with 4, 9v batteries in series and the
> US224 runs off a laptop but there's not enough signal. If someone has
> an easy circuit for a battery powered, quiet, compact amplifier stage
> that will bump the signal up a bit that I could try that would be
> great. Thanks as always, s.


   Kind regards

   Peter Larsen

-- 
    ************************************************************* 
    *          My site is at: http://www.muyiovatki.dk          *
    *************************************************************