Re: Eheim noise/ low flow

Make sure the rubber gasket around the top is intact and sealing.  Sounds to
me like you are taking in air around the top, and that also causes the leaks
you describe....  You can get replacement gaskets easily

-- 


---------------------------------------------------------------------
"Are you still wasting your time with spam?...
There is a solution!"

Protected by GIANT Company's Spam Inspector
The most powerful anti-spam software available.
http://mail.spaminspector.com


"Jim Morcombe" <[EMAIL PROTECTED]> wrote in message
news:[EMAIL PROTECTED]
> Are you sure you haven't got air in it?
> Make sure the canister is absolutely full of water before turning it on.
>
> Jim
>
>
> Seweryn <[EMAIL PROTECTED]> wrote in message
> news:[EMAIL PROTECTED]
> > Hello peoples!
> >
> >  Got a question about my 4 month old Eheim 2213...
> > After running silently for a while, it has developed a rattly hum when
> > running. I cleaned the canister out, squeezed the filter pads, rinsed
the
> > substrate, made sure the tubes were clear, and disassembles the outer
pump
> > components and cleaned them. But it still rattles! And it seems that the
> > flow rate has decreased. The only addition to the filter media was to
add
> a
> > thin extra layer of floss right before the white pad. Any ideas what's
> going
> > wrong?
> > Along the same lines...
> > - When (if ever) should I replace the coarse and fine substrate??
> > - Do I have to replace the white pad every few months, or can I just
give
> it
> > a good rinse? Could I use some generic floss instead?
> >
> > Thanks for any advice,
> >
> > - Seweryn
> >
> >
>
>