Re: CO2 Diffuser question

I built the DIY CO2 system using the glass bells system also and seems to be
operating very well.Can see the bubble going into the glass bell and then
collecting on the underside of the ceramic diffuser before dispensing into
the tank.

So far i am impressed.Its only been running 4 days but can see slight
improvement in the plants.

I am curious as to how far in the tank others ,who have the glass bell ,
have placed it in the tank..Do you place it a few inches off the bottom or
half way up the side of the tank etc?

I used a tablespoon of yeast to 2 cups of sugar and add 1.5 litres of 80
degrees F water.Would be curious as to other formulas that produce results


"gizmo" <[EMAIL PROTECTED]> wrote in message
news:[EMAIL PROTECTED]
> I have a pressurized CO2 system, the diffuser is a glass bell that is
> usually 1/3 filled with water other 2/3 are the gas which is diffusing
into
> the water thought a kind of a hard membrane - which worked very well. for
> some reasons the water are no longer in the bell which also means I cannot
> see the CO2 bubble count. could the CO2 pushed out the water I think it
> did.... does this indicates any problem ?
> 10x
>
>
> gizmo
>
>
>