FS: SCSI drive cases; parts organizers, aluminum field case for parts and tools

Photos available on request for most of this. Note email instructions at bottom. 
Willing 
to ship at buyer's expense. Note if you are reading this from the US the prices below 
are 
Canadian $ - multiply by about 0.75 to get the US $ equivalent. 

Parts/Maintenance/Tool Case

Aluminum suitcase / service case. This is one of the standard aluminum cases you see 
in 
Revy and Home Depot. Looks like a small suitcase. Outside: handle, locks, two 
retaining 
clips, surface of textured aluminum with heavier chromed and riveted corners, four 
feet 
on the bottom. Inside: reconfigurable soft storage compartments in bottom, removable 
vinyl tool holder panel in top part. Good condition, no signs of wear. 18"w x 14"d 
x6"h 
These generally sell for about $52 (incl. tax) in Revy-Rona. I'd like $30 but open to 
reasonable offers. 

SCSI External Cases 

Case 1. Grey plastic. High density 50 pin connectors on rear but can change to 
standard 
SCSI 1 50 pin if you like. Up to 5.25" drives. Power supply. Can have fan but the 
drive I 
had in there was a slow scsi cdrom and it didn't need it so I snipped it out to make 
it 
totally silent - standard size fan though and easily replaced. ID select, On/Off 
switch 
and AC power connect on rear. This looks identical to a unit ATIC is selling for 
$80+tax. 
Asking $20 OBO. 

Case 2. Similiar to case above. Originally came from Plextor containing a SCSI CD 
drive 
that was later moved to be internal to a computer so the case was left over. Has audio 
jacks and SCSI ID select on rear. Rear SCSI connectors (2) are HD50 but I can replace 
with the standard SCSI 1 50 pin if you like. Power out on rear as well. Asking $25 
OBO. 
  
Storage units - parts organizers.

Parts cabinet - black metal, 50 clear plastic drawers; mostly small size but bottom is 
width of cabinet and 2nd to bottom is 1/4 of cabinet width; remainder are 1/5th of 
cabinet width. Basically as new with compartment separators. There are cut-outs on 
rear 
for screws, to wall mount it if desired. Cost $42 at Revy-Rona, asking $25 OBO

Parts cabinet for counter top or shelf, dark grey plastic, 6"d x 7.5"h x 10" w, 15 
drawers which can have 2 dividers each to make up to 3 compartments per drawer. $10 
OBO. 
 

2 floppy storage units for 3.5" floppies, about 8" long with clear tops, movable 
dividers 
and hinged lids plus a bunch of blank 1.44MB blank floppies that typically were used 
once 
for backups and then erased. Both units and all the floppies for $10 OBO
 


 --

 To email me use the reply address but note it has a dot and sequence of three digits 
which you need to remove.