
www.Usenet.com
| <-- __Chronological__ --> | <-- __Thread__ --> |
Your local home store should (may) have moisture dectors but they are expensive especialy if you are only using them once. arround $150 but there are cheaper ones. they have 2 metal probes that stick into wood or concrete and send a current between the probes . by measuring the resistance they give you an aproximate value of the moisture. you can also check Ebay and you can always sell it on ebay after you are done with it. flooring contractors and building inspectors use them. to cure your problem you wont be cutting into the wall you may just need to raise the grade arround the house to make sure water runs away from the house or you will be excavating arround the house and installing a drain tile / perferated pipe covering it with a silt sock and then a foot or so of gravel. over the gravel you use garden fabric or plain (not asfault) construction paper then dirt. you hook the drain tile tube into aditional tubes that you run out into your yard underground and inside gravel This is probably overkill though since you say it was not a normal rain that caused this. the ground is probably very saturated and time will cure it. bob marencin www.yourepair.com "John Johnston" <[EMAIL PROTECTED]> wrote in message news:[EMAIL PROTECTED] > Looking for a way to detect or measure the water > behind a wall, or if a water spot is indeed wet, > or all dried up. > > I'm trying to avoid cutting holes where there is not > an issue (small spot after tornado a few weeks ago). > > Or ... is there a cheap camera/scope I can stick into > a wall and hook up to a small monitor? > > Thanks!
| <-- __Chronological__ --> | <-- __Thread__ --> |