Re: SUSPEND/RESUME problem

Thanks Hans!

It worked :) I should've known, it's so obvious now!

Laskas

"Hans-Jürgen Ortmann" <[EMAIL PROTECTED]> wrote in message
news:[EMAIL PROTECTED]
>
> "Ricardo Lascas" <[EMAIL PROTECTED]> schrieb im Newsbeitrag
> news:[EMAIL PROTECTED]
> > Hi,
> >
> > Im trying to suspend/resume a voice call using a AVM FritzUSB v2.0 with
> the
> > lates drivers. Everything goes well with the Q.931 signaling but CAPI
> fails
> > to complete the MSC (CAPI-PIII, page 34), it does not send the
> > CONNECT_B3_ACTIVE_IND. The B channel is up but I get no data blocks from
> > CAPI ...
> >
> > Any wild guess?
>
> wild guess: after receiving the FACILITY_IND with a new PLCI, this PLCI is
> in a default mode, i.e. the BProtocols are also reset to defaults. Try
> changing the BProtocol to voice (SELECT_B_PROTOCOL) before issuing a
> CONNECT_B3_REQ.
>
> HansJuergen
>
>