Re: CDSSPICE OUT OF MEMORY

 If, somehow, your models can not be translated into spectre syntax, 
does not mean that you have to netlist with cdsSpice. You can still use 
spectre direct netlisting rather than spectre-sockets, and leave your 
models in spice syntax. For example, I know of a designkit that contains 
hspice models for device modelling and these are used in AHDL modules 
(subcircuits) in the model library; thus no spectre syntax and it works 
like a charm with spectre-direct.

 Direct netlisting is an improvement for both designers and 
eda-support. You could give it another go, and look at the migration 
toolbox and its' manuals.

tritue wrote:
> Hi All
>
> I use to run the spectreS simulation (because the models I have can not be
> easily translated into spectre model). I have some time to time a CDSSPICE
> out of memory error message. This error could run for 5-10 minute before the
> simulation can start.
> Is there any command that will allow more memory for the CDSSPICE process
> when we launch the analogArtist SpectreS ??
>
> Thank you.
>
> Tritue Truong